JT & Fuel Conditioning Spec Sheet

Company Name

Project Location

Quote Date:

Contact Name

Delivery Expected:

Phone

Conditions

Gas flow rate(Required)

MMSCFD

Operating Pressure(Required)

MMSCFD

Operating Pressure(Required)

°F

(Note: If a range is given in these conditions, ARC will model various combinations and provide results)

Inlet Water Content lb./MMSCF

(If unknown, gas will be assumed to be saturated)

Gas Analysis Attached(Required)

Yes

For JT & Fuel Conditioning Units, gas composition is imperative.

(Note: If the analysis pressure and temperature vary from the above, ARC will simulate pressure/temperature increases or decreases from the analysis to obtain specified inlet conditions)

Outlet Gas Requirements, Complete all that apply but at least one

Gas Heating Value, BTU/scf

Gross

Gas Heating Value, BTU/scf

Net

Pressure, PSIG

Max.

Pressure, PSIG

Min.

Water Dew Point

°F at

Water Dew Point

PSIG

Water Content

lb/MM

Hydrocarbon Dew Point

°F at

Hydrocarbon Dew Point

PSIG

Other

(Note: Arc will attempt to meet all the requirements marked, adjusting inlet and outlet pressures.)

Outlet Liquid Requirements, Complete all that apply:

Liquid Storage Pressure (ARC will model flash gas & RVP

PSIG

RVP (ARC will model flash gas and required pressure)

°F

Temperature (ARC will include Equipment to maintain temp)

PSI

Stabilizer (Mark here and describe any additional requirements for Stabilized Liquids

Stabilizer

Specific Design Requirements and Options:

Desired Equipment MAWP (design)

PSIG at

Desired Equipment MAWP (design)

°F (High Pressure side)

Desired Equipment MAWP (design)

PSIG at

Desired Equipment MAWP (design)

°F (Low Pressure side)

(Note: ARC will model and determine amount of Methanol required to stay 10 degrees above solids formation.)

Brand/Model of Methanol Injection pump preferred?

ARC will determine the best design for the application i.e. Exchangers, Filters, Coalescers, Separator, etc. However, if you have specific type of equipment or specific brand of controls and instruments, please note as such here.

Get Started

We’re committed to providing the best equipment to meet your needs. If you have questions or comments, don’t hesitate to contact us. Our knowledgeable staff are standing by to help you.